Knowledgebase: FTPS (SSL/TLS)
|
Procedures for setting up an FTP site using SSL/TLS.
Posted by SRT HelpDesk Admin on 16 March 2005 05:19 PM
|
|
|
Please refer to our quickstart guide for setting up SSL/TLS: http://southrivertechnologies.com/docs/titanftp/Titan%20FTP%20FTPS%20&%20Public%20Key%20Certificate%20Authentication%20Quick%20Start%20Guide%20Master.pdf You can run the standard Titan FTP Server wizard to configure a standard server. Once the server has been created, go to the FTPS/SSL tab for the server and enable SSL/TLS. You'll need to create a certificate for use by the server. Click the Certificate Management button then click create to generate a new certificate. Once this has been completed, you'll need to open port 21 for standard FTP and Explicit FTP (AUTH SSL/TLS) and port 990 for Implicit SSL/TLS. Also, you should enable the PASV mode feature for Titan FTP Server and open a port range on your DSL router or cable modem. Under your server go to the Connections node. On the Connections Advanced tab you will see a check box that reads "Allow PASV mode connections". Make sure this box is checked. For more information on configuring Titan FTP Server for use with a DSL router or cable modem please see our quick start guide: http://southrivertechnologies.com/docs/titanftp/Titan%20FTP%20%20Router%20Firewall%20Configuration%20Quick%20Start%20Guide.pdf | |
 (938 vote(s)) This article was helpful This article was not helpful |
|
Comments (0)